Machine Settings
1. Stitch selection: Straight Stitch.
2. Needle Position: Left or right depending on which side you are sewing the piping on.

Procedure
Sew Beads: Up to 5mm
1. Snap the beading foot on the machine.
2. Set stitch pattern to Zigzag, stitch width to the size of the beads or 1mm bigger than the beads.  Stitch length at 3mm to 5mm.
3. To secure ends of beads, pull 5 to 6 inches of thread top & bottom
4. Then set the stitch length to “0”, sew 3 to 4 zigzag
5. Change the stitch length back to normal. 
6. After you have completed sewing
7. Set stitch length to “0”
8. Sew 3 to 4 zigzag stitches to secure.